Magnetic Wall Hanging

I am into metal in case you haven't noticed. :) For this project I used some metal from a roll of galvanized flashing that I purchased at our local Lowe's.

Once I had the 3 pieces cut I used masking tape around the edges, because this stuff is SHARP! I have also read that you can sand the edges, so I might have to give that a try.

I then covered the metal pieces with paper and used my Crop-a-dile to insert the eyelets.

To finish this project I tied ribbon between the pieces and a longer one on top to use to hang. I then made magnets out of buttons and flowers to use to attach notes, photos, etc.